Roland VS-640i User Manual download pdf (Page 133)

131

Part of

Practice

Using Media Take-up System

Use The Media Take-up System When The Output Accompanied With The Pull-back Operation is Performed

Note: The media take-up system (hereinafter called take-up system) is optional part.

Note: For information on how to assemble and install the take-up system, refer to the user’s manual of the

take-up system.

Note: For information on the output not accompanied with the pull-back operation, refer to the user’s manual

of the take-up system.

If you use the take-up system when the output accompanied with the pull-back operation is performed,

perform the following procedures before use of it.

Procedure



Move the dancer roller toward the rear.



Turn on the sub power, and select “TU2” by pressing

when the left gure is displayed.

Then, operate according to the procedure in the user’s manual of the media take-up system.

Use Conditions of Take-up System When “TU2” is Selected

The use conditions vary according to the selections of “TU2” (accompanying the pull-back operation) and “TU”

(not accompanying the pull-back operation). When you select “TU,” be sure to comply with the use condi-

tions in the user’s manual of the take-up system. When you select “TU2,” be sure to comply with the following

conditions.

 Do not operate the manual switch on the take-up system leaving the loading lever lower.

 Do not feed the media reversely by pressing

It may cause an error because the media is pulled with excessive force.

 Do not use the automatic cut-off function.

When the setting to execute automatic cuto of the media is made on the RIP software, media cuto is

performed when printing of one page nishes. When you're performing continuous printing and take-up

for two or more pages, turn o the automatic-cuto feature on the RIP software. Take-up quits as soon as

the media is cut o.

About Length Output At One Time

If the length of output at one time is too long, the media may get soiled by touching the work oor. To avoid

the media from getting soiled by touching the oor, output the media by about 300 mm.

To output by limiting the length, use the function of RIP software.

 The setting method when using Roland VersaWorks is continued on next page.

SETUP SHEET

TU2

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 175 176

No comments

Roland VS-640i User Manual Page 133