Roland VS-640i User Manual download pdf (Page 159)

157

FAQ

An Error Message Appears

This describes the error messages that may appear on the machine's display, and how to take

action to remedy the problem. If the action described here does not correct the problem, or if an

error message not described here appears, contact your authorized Roland DG Corp. dealer .

[ALIGN POINT POSITION INVALID]

An attempt was made to set an align point at a location where the setting cannot be made.

No align point can be set when the angle of the base point and the align point is too large. Reload the media

correctly, so that the angle is minimized, then set the base point and the align point again to match the crop

marks.

 P. 123, “Performing Printing and Cutting Separately”

[HEATING TIMEOUT CONTINUE?]

The print heater or dryer did not reach the preset temperature.

This occurs because the temperature of the location where the machine is installed is too low. We recommend

raising the temperature. To continue waiting for the temperature to rise, press

. To start printing im-

mediately, press

[CARRIAGES ARE SEPARATED]

The cutting carriage and the print-head carriage were improperly disconnected.

A problem such as a media jam occurred, impeding correct operation. Operation cannot be continued. Switch

the sub power o, then back on.

[CROPMARK ERROR NOT FOUND]

Automatic detection of crop marks could not be accomplished.

Load the media at the correct position and perform detection of crop marks again. Depending on the media,

it may not be possible to detect crop marks automatically. If repeating automatic crop-mark detection results

in an error again, then perform manual crop-mark detection.

 P. 123, “Performing Printing and Cutting Separately”

[CAN'T PRINT CROP CONTINUE?]

The size of the data including the crop marks is larger than the printing or cutting area of

the loaded media.

To continue performing output without correcting this, press . At this time, the portion extending

beyond the printing or cutting area and the crop marks are not printed. To stop output, stop sending data

from the computer, then raise the loading lever. Make the printing or cutting area wider, such as by replacing

the media with a larger piece of media or by changing the positions of the pinch rollers, then send the data

again.

The size of the data being output is too small.

Make the scanning-direction size of the data at least 65 mm (2.6 in). To continue performing output without

correcting this, press

. At this time, the data is output without printing the crop marks. To stop output,

stop sending data from the computer, then raise the loading lever. Change the size of the data, then send the

data again. There is no limitation in the size of the data in the media-feed direction.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 175 176

No comments

Roland VS-640i User Manual Page 159