Roland V-1600HD Owner's Manual download pdf (Page 17)

Part Names and Functions

4. RGB/COMPONENT IN and THRU Connectors (Channel 12)

These are for inputting the RGB or analog-component signals assigned to channel 12. Note, however, that unlike for channels 9

and 10, this is a D-Sub 15-pin input connector. Thru-out for an external monitor is the same as for channels 9 and 10.

5. RGB/COMPONENT IN and THRU Connectors (Channel 11)

The connection methods are the same as for the RGB/COMPONENT IN and THRU connectors for channel 12.

* When connecting analog-component output from a video camera or other sources to 11 or 12, use an adapter cable for BNC to D-Sub 15-pin.

* When terminating RGB/COMPONENT input at the V-1600HD, set the TERMINATOR switch to [ON]. For thru-out, set it to [OFF].

fig.SDI-in.eps

These are for inputting the SDI signals assigned to channels 1 through 8. Each has a thru-out (THRU) connector, enabling output

to an external monitor.

* In the case of mixed HD-SDI and SD-SDI input, automatic up-conversion or down-conversion is performed according to the selection for

OUTPUT FORMAT.

* If the aspect ratio of input signal differs from the OUTPUT FORMAT setting, the output is letterboxed. You can also use the menus to select

cropping or squeezing. Refer to “Menu Operations and Menu List” (p. 47).

fig.DVI-in-out.eps

1. DVI-D/HDMI OUT Connectors

The final output of the V-1600HD (program output) is output from the PGM connector. Output from a desired point of the V-

1600HD (PGM, PVW or AUX) can be made from the [2] connector. You can use the menus to select the output point. Refer to

“Menu Operations and Menu List” (p. 47).

2. DVI-D/HDMI IN and THRU Connectors (Channel 12)

These are for inputting the DVI-D signals assigned to channel 12. For thru-out to an external monitor, make the connection to the

THRU connector.

* By default, DVI-D or HDMI input is not assigned to channel 12. Refer “Connecting a Computer (DVI-D)“ (p. 21) to change assignment.

3. DVI-D/HDMI IN and THRU Connectors (Channel 11)

The connection methods are the same as for the DVI-D/HDMI IN and THRU connectors for channel 12.

* By default, DVI-D or HDMI input is not assigned to channel 11. Refer “Connecting a Computer (DVI-D)“ (p. 21) to change assignment.

By using an adapter or cable for DVI-D to HDMI, you can also connect equipment capable of HDMI output.

DVI-D/HDMI input and output on the V-1600HD are not compliant with High-bandwidth Digital Content Protection (HDCP).

SDI IN Section

DVI-D/HDMI IN/OUT Section

123

1 ... 16 17 18 ... 68

No comments

Roland V-1600HD Owner's Manual Page 17