Roland Vs-880 Owner's Manual download pdf (Page 75)

VS-880 Application Guide

When bouncing multiple recorded tracks down to a single mono or stereo track, you may often want to

add effects during the bouncing process. For example, you might want to take the six background vocal

tracks (see Bouncing Tracks 1 through 6 to 7 & 8), and add some reverb to each individual vocal track

during the bounce down.

To accomplish this, you will need to first assign tracks 1 through 6 to the inputs of an internal mixing buss

(inside the VS-880). You will then assign the outputs of that mixing buss to Tr. 7-1 and Tr. 8-1. You will also

need to select the tracks to add effects and assign them to the effect of choice. The effect device output

must then be added into the final mix. Once you have made your level, EQ, panning, effects, and other

creative choices, you will record the six tracks down to two tracks using his internal mixing buss.

ACTION: Effects Processing - Using The Internal VS8F-1 When

Bouncing

Using the INPUT MIX/TRACK MIX mode:

Use the following procedure to bounce tracks using the INPUT MIX/TRACK MIX mode:

A. Select TRACK MIX mode

1. Hold [SHIFT] and press [SELECT] (under MIXER MODE), to choose TRACK MIX mode.

B. Route Tracks 1 through 6 to buss 7-8

2. Press [CH EDIT] 1 to select Track 1.

3. Hold [SHIFT] and press [Input/BUSS] (CH EDIT 1)

4. Use the TIME/VALUE dial to select “7-8” as the “BUSS SEL” for Track 1.

5. Press [CH EDIT] 2, select “7-8” as the “BUSS SEL” for Track 2.

6. Repeat steps 2-5 for Tracks 3, 4, 5, and 6.

C. Route the source tracks to the EFFECTS Processor

7. Press [CH EDIT] button 1 to select Channel 1.

8. Hold [SHIFT] and press [Effect 1] (CH EDIT button 7).

9. Use the TIME/VALUE dial to select “PstFade.”

10. Repeat steps 7-9 for all desired tracks by selecting the corresponding track number.

D. Select the EFFECTS

11. Press [EFFECT] button (under EDIT CONDITION) until “EFFECT 1?” (or 2 if you have

chosen to use EFFECT # 2) is displayed.

12. Press [YES].

13. Use the TIME/VALUE dial to select the desired effect.

14. Press [YES] to confirm your selection.

D. Route the outputs of the EFFECTS Processor

15. Press the [EDIT] button (found over the MASTER FADER) until “EFFECT 1 RTN To = MIX”

is displayed.

16. Use the TIME/VALUE dial to select “EFFECT 1 RTN = 7-8”, to route the effect to Buss 7-8.

17. Press the right [PARAMETER>>] button and use the TIME/VALUE Dial to set the return

level. This is the Volume setting for the output of the effect.

Using The Internal VS8F-1 Effects When Bouncing

1 ... 74 75 76 ... 142

No comments

Roland Vs-880 Owner's Manual Page 75