Roland PC-600 User Manual download pdf (Page 27)

Chapter 2 - Basic Operation

* Only when using rolled material

Pass the stopper onto the shaft to match the width of

the roll material to be used. (The shafts (2 pieces),

stoppers (2 pieces), and stopper retaining screws (2

pieces) are included with the stand.)

When fitting the stoppers onto the shaft, loosen the

stopper retaining screws and pass the stoppers onto

the end of the shaft where the hole is present.

Shaft

Stopper retaining screws

Stopper

Rear

Front

Sheet hanger

Shafts

Stoppers

Set the two shafts in place and attach the brake.

Rear view

Brake

Shaft

Sheet hanger

Screw

Sheet hanger

Install the two shafts on the sheet hanger and place

the roll material on top of the shafts.

When you are using roll material, make the setting

on the PC-600 to set the prefeed function to

[ENABLE] (the factory default is [ENABLE]).

Before performing printing or cutting, the length of

material required for output is automatically pulled

out from the roll, then returned to the rear, where it

is left slack. If output is performed without carrying

out this operation first, printing or cutting may be

misaligned, or the material may come loose or jam.

If the setting for disabling the prefeed function has

been made on the machine, then pull out from the

roll the length of material required.

(If the prefeed function is enabled, there is no need

to pull out material.)

Move the brake toward the shaft

Not OK

1 ... 26 27 28 ... 65

No comments

Roland PC-600 User Manual Page 27