Roland PC-600 User Manual download pdf (Page 36)

Chapter 2 - Basic Operation

2-6 Self-test

The PC-600 is equipped with a “self-test” function to allow you to check whether or not it is capable of operating normally. If the PC-600

is not performing correctly, follow the steps below to perform a self-test.

A computer is not required in order to carry out the self-test.

Hold down the

key on the panel while you turn

the [POWER] key (sub power) on.

Load material and lower the sheet loading lever.

Gently close the front cover.

Operations is normal if the figure shown at below.

Leave on the main power for the PC-600, and

switch off the sub power.

Install blade holders and four-color (CMYK) ribbon

cartridges on the PC-600.

Self-test starts.

After the operation check has finished, raising the sheet loading lever cancels the operation check mode. After that, the unit just as it

does when the power has been switched on in the normal manner.

Do not allow hands or hair to come

near the platen while the carriage is

in motion.

Failure to do so may result in injury due to

sudden movement of the carriage when the

power is switched on/off, when the sheet

loading lever is raised or lowered,

or when the [CUT TEST] key, [SHEET CUT]

key, [DATA CLEAR] key, or [HEAD

CLEANING] key is pressed.

Full-color

printing

Settings on the machine

Cutting

1 ... 35 36 37 ... 65

No comments

Roland PC-600 User Manual Page 36