Roland PC-600 User Manual download pdf (Page 48)

Chapter 3 - User's Reference

Setting the Crop Marks, Base Point, and Align Point

– Remove the Printed Material, then Reload the Material and Perform Cutting –

This feature is for performing position alignment in cases where printing is performed, after which the material removed from the

machine for further processing (such as laminating), then again loaded on the machine for cutting.

* Setting crop marks to [ENABLE] changes the printing/cutting area. For more information, see "3-5 About the Printing/Cutting Area."

* When reloading a portion that has already been printed and cut off of the roll, them make sure there is at least 90 mm (3-9/16 in.)

from where printing ended to the rear edge of the material (where it was cut from the roll).

When the material is to be cut off automatically, then at the PC-600 driver [Driver Options] tab, set [Page Spacing] to 90 mm (3-9/16

in.) or more.

Hold down the [ALIGN POINT] key on the panel

while you turn the [POWER] key (sub power) on.

The ALIGN POINT LED and the POWER LED

lights up.

Use the and keys to make the LEDs for

CARTRIDGE HOLDER 1 and 3 light up.

Use the and keys to make the LED for

CARTRIDGE HOLDER 5 light up.

The setting is completed when the [POWER] key is

used to switch off the sub power. Crop marks are

now set to [ENABLE].

Press the [POWER] key (sub power) to switch on

the power.

You can also enable or disable crop marks by

making the setting using the driver. When you are

making the setting with the driver, steps 1 through 5

are not necessary.

Send the printing data from the computer.

Three crop marks are automatically printed on the

left and right areas at the front edge of the material.

Rear

Front

Crop marks

When printing finishes, raise the sheet loading

levers, remove the material, and perform lamination

(or whatever further processing needs to be done).

When done, reload the material in about the same

position used for printing and lower the sheet

loading levers. (The SETUP LED lights up.)

Rear

Front

1) Set the base point

Use the arrow keys to move

the tip of the alignment tool

to the square crop mark at

the lower right area of the

material, then press the

[BASE POINT] key.

• The align point cannot be set to both the lower left and upper right points.

• The align point cannot be set if the angle between the base point and the align point is 5 degrees or more.

• Marks set with the application software (such as crop marks) cannot be used.

2) Set the align point

Use the arrow keys to move

the tip of the alignment tool

to the crop-mark corner in

the length direction of the

material (at either the lower

left or upper right).

Then press the [ALIGN

POINT] key.

Use the and keys to move the carriage to the

center of the platen.

Install the alignment tool on the cutting carriage.

1 ... 47 48 49 ... 65

Comments to this Manuals

No comments

Roland PC-600 User Manual Page 48

Comments to this Manuals

Related products and manuals for Print & Scan Roland PC-600