Roland PC-600 User Manual download pdf (Page 32)

Chapter 2 - Basic Operation

Open the front cover and move the tip of the blade

to the point where the cutting test is to be started.

When carrying out cutting for the first time, or when the material or tool has been changed, a cutting test is performed to verify how the

tool cuts.

2-4 Cut Test

Move the tool force control slider on the right-hand

side of the unit all the way to the front (for mini-

mum blade force).

1) First peel off the round section (shaded as shown ).

>> When it can be peeled by itself, without disturbing the square, the cutter

force is set appropriately.

2) Next, peel off the square, and look at the backing behind it.

>> The optimum blade pressure is correct if you can clearly make out the

lines left by the blade.

Use the tool force control slider to adjust the blade force so that results like

those shown above are not obtained.

Gradually increase the cutter force until you reach the optimum level.

* Note that an area of approximately 2 square centimeters (a

little less than a square inch) is required to make a test cut.

Hold down the [CUT TEST] key until you hear a

beep.

Cut test starts.

Peel off first

Then peel

this off

Origin

Do not allow hands or hair to come

near the platen while the carriage is

in motion.

Failure to do so may result in injury due to

sudden movement of the carriage when the

power is switched on/off, when the sheet

loading lever is raised or lowered,

or when the [CUT TEST] key, [SHEET CUT]

key, [DATA CLEAR] key, or [HEAD

CLEANING] key is pressed.

1 ... 31 32 33 ... 65

No comments

Roland PC-600 User Manual Page 32