Roland PC-600 User Manual download pdf (Page 31)

Chapter 2 - Basic Operation

To Perform Long Printing/Cutting

When performing printing or cutting over a length of 1 m (39-3/8 in.) or more, first feed out the required length of material. Then follow

the steps below to load the material.

If the setting for enabling the prefeed function has been made on the PC-600, then skip steps 6 and 7.

Perform steps 1 through 3 of "2-3 Loading the

Material".

Position the pinch rollers as shown in the figure.

Lower the sheet loading levers to secure the material

in place.

Use material that is wider by 50 mm (2 in.) or more

than the width of the printing or cutting to be

performed.

Feed out the length of material to be printed or cut.

Attach the stoppers to the edges of the roll material

and tighten the screws to secure in place.

Roll material

Stopper retaining screw

When you are performing long printing, expansion or contraction of the material may cause colors to be misaligned.

For roll material in particular, the time required for the material to uncurl and acclimatize to the ambient temperature

and humidity is different for the outer portions and the central portion of the roll.

Before you perform long printing, pull out the length of material to be printed from the roll and let it allow to stand for

about 30 minutes to an hour to allow it to become acclimatized to the environment, then load the material.

Make sure that the

material remains held by

the pinch rollers.

If the material does come

loose from the pinch

rollers, set it in place

again.

Return the fed-out material.

Make sure the

material lies over the

front and rear sensors.

Material

alignment

stickers

25 mm

(1 in.)

or more

Material

alignment

stickers

25 mm

(1 in.)

or more

1 ... 30 31 32 ... 65

Comments to this Manuals

No comments

Roland PC-600 User Manual Page 31

Comments to this Manuals

Related products and manuals for Print & Scan Roland PC-600