Roland VM-C7200 Owner's Manual download pdf (Page 56)

Using On-Board Effects

Turn [V2](POSITION) to define the insertion point of the

effect.

The insertion points are as listed below. (Turn [V1] for “MASTER FX” to

select from the following: OFF, MAIN, MONITOR.)

• OFF - No effect

• INPUT PRE EQ - Insert before EQ on Input channels

• INPUT PRE FDR - Insert before fader on Input channels

• MULTI IN PRE EQ - Insert before EQ on Multi In channels

• MULTI IN PRE FDR - Insert before fader on Multi In channels

• SEND/RTN (INT) - Effect receives mono input from a Flex Bus and

produces a stereo effect that can be routed to Main out or Cue bus,

etc. Signal is sent to each effect via its like-numbered Flex Bus.

• INT FBUS - Insert on Flex Bus (Internal mode)

• EXT FBUS - Insert on Flex Bus (External mode)

• MAIN - Insert on Main out

• MONITOR - Insert on Monitor out

The precise insertion point

of the effects can be seen on

the “Block Diagram” that is

supplied with the

processor.

examples

• When using an equalizer or compressor on an input signal itself,

insert the effect directly on the Input or Multi In channel.

• When using a reverb for multiple channels, use SEND/RTN (INT) to

create a mono-send/stereo-return loop effect, or insert the effect on a

Flex Bus for a mono-send-return loop effect.

• When using the Total Compressor on your entire mix, insert it on the

Main out.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 99 100

No comments

Roland VM-C7200 Owner's Manual Page 56