Roland VM-C7200 Owner's Manual download pdf (Page 78)

Using EZ Routing Templates

Set the input gain of each signal on the console.

1. Press [INPUT].

2. Press [PREAMP GAIN].

3. Use the faders to adjust the input gain level of each source.

• If you are using any condenser microphones, activate their

PHANTOM power.

Adjust each EQ as necessary.

1. Press [CH EDIT] on the desired channel.

2. Press [PAGE UP] [PAGE DOWN] to select the “EQ BAND” page.

3. Use CURSOR [UP] [DOWN], [V1]-[V6] and [F1]-[F6] to set the EQ.

Set the channel levels.

1. Press [CH LEVEL].

2. Adjust each channel’s output level using its fader.

Set up the monitors.

• Flex Bus 9-12 signals can be sent out of the system via the FLEX BUS

OUT 9-12 jacks. You can send and balance the signals sent to

FlexBusses 9-12 according to the performers’ needs.

• You can monitor the overall sound through the MONITOR OUT.

• The Talkback signal is assigned to Channel 24.

• You can also send a rough mix into a DAT or MD from the

MONITOR OUT.

• Adjust the live elements’ signals (E. Bass, E. Guitar, Acoustic Guitar,

Choruses 1-3, Lead Vocal) at [MULTI IN] 1-8 Channels.

Owner’s Manual “Gain,

Phantom Power Supply,

Phase and Attenuator”

(p.68)

Owner’s Manual

“Adjusting Various

Channel Settings

(Equalizer, etc.)” (p.78)

Owner’s Manual “Setting

up ON/OFF, SEND LEVEL

and PAN for a Channel”

(p.70)

Owner’s Manual “Mixing

Procedure 2 (Output and

Monitor)” (p.84)

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 99 100

No comments

Roland VM-C7200 Owner's Manual Page 78