Roland MC-307 Owner's Manual download pdf (Page 110)

110

Chapter 6 Making Original Patches

F-ENV: LEVEL1–4 (ENVELOPE LEVEL1–4)

Specifies the cutoff frequency at each level. You can make

settings for the four parameters, Level 1–4.

Raising this setting will also raise the cutoff frequency.

Range: 0–127

Changing the Volume Level and

Localization

(AMP and ENVELOPE)

“AMP:” are used to define parameters concerning the

volume level and localization.

“A-ENV:” let you specify this type of time-varying change in

volume (the Amplifier Envelope).

Procedure

1. Press the [PTN] button.

2. Press [PART SELECT] then, Press [R] part buttons to

select the part R.

3. Press [F1 (PACH)] and [F1 (EDIT)] button, in that order.

The menu screen for rhythm set editing appears.

4. Press the [CURSOR (up)] button.

5. Press the [F4 (AMP)] button.

6. To edit parameters in the “AMP:,” press [F1 (AMP). To

edit parameters in the “A-ENV:”, press [F2 (AENV)]

button.

One of the editing screens appears.

7. Press the[F3 ( )]/[F4 ( )] button buttons to select the

parameter to be edited.

8. Press an appropriate keyboard pad to select the key for

which you want to define the parameter.

(You can listen to the sound to confirm which tone is

selected.)

9. Specify a value using the [VALUE] dial or the [INC/

DEC] buttons.

10.After the value is specified, press the [EXIT] button to

return to the previous screen.

Parameters that can be set

- AMP:

TONE LEVEL, TONE PAN, RANDOM PAN SW, ALT

PAN DEPTH

- A-ENV:

VELO SENS, VELO TIME SENS, TIME1–4, LEVEL1–3

* See the following sections for descriptions of the setting ranges

and contents of the respective parameters.

AMP parameters

AMP: TONE LEVEL

This setting adjusts the volume of each tone. This is used

mainly to adjust the volume balance between tones.

Range: 0–127

-> “Adjusting the Volume of Each Part (Part Level)” (P.

23)

AMP: TONE PAN

This parameter sets the stereo location for each tone.

* The pan of the overall Rhythm set can be modified and set for

each pattern by the Setup parameter Part Pan. The Tone Pan

value will be added to this setting.

Range: L64–63R

-> “Adjusting the Pan of Each Part (Part Pan)” (P. 23)

AMP: RANDOM PAN SW

This setting causes the stereo location to change randomly

each time a note is played.

Range: OFF, ON

* The TONE PAN and ALT PAN DEPTH setting will be

ignored by Tones for which the Random Pan Switch is turned

on.

AMP: ALT PAN DEPTH (ALTANETE PAN DEPTH)

This parameter causes the stereo location of the sound to

alternate between left and right each time a note is played.

When this parameter is set in the L direction, the sound will

alternate in the order of left -> right-> left-> right. When set

in the R direction, the sound will alternate in the order of

right -> left-> right-> left.

Higher settings will cause greater change.

Range: L63–63R

A-ENV (AMP ENVELOPE) parameters

A-ENV: VELO SENS (VELOCITY SENSE)

Specifies how the depth of the amplifier envelope will be

affected by the strength of your playing velocity.

If velocity sensitivity is set to a positive (+) value, the volume

will be loud when you play strongly and soft when you play

softly. As this value is increased, the volume difference

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 215 216

Roland MC-307 Owner's Manual Page 110

Comments to this Manuals