Roland MC-307 Owner's Manual download pdf (Page 40)

Chapter 3 Giving Variation to Pattern

playback will use the M-FX settings of the pattern that is

selected at that time. This means that what you hear when the

RPS plays back may be somewhat different from the original

phrase.

* If a rhythm part phrase is assigned, the Rhythm Mute settings

will be ignored during RPS playback.

* Each phrase is played back by a special RPS part 1–16 which

corresponds to each keyboard pad, but phrases assigned from a

rhythm part will be played back using the rhythm part of the

currently-selected pattern. For this reason, a different rhythm

set than that of the registered pattern may sound in some

cases. If the pattern changes so that a different rhythm set is

selected, the sounds of the rhythm set which will play the RPS

will also change.

Setting up a Part for RPS

Unlike ordinary pattern playback, RPS is played back using

RPS parts that are specially set up for RPS. Patterns assigned

to the pads [1] to [16] are used to play back the [1] to [16] RPS

parts.

The settings for these RPS parts can be altered.

* See the following sections for descriptions of the respective

parameters.

Procedure

Bring up the RPS setup screen.

1. Press the [SYSTEM] button.

2. Press the [F1 (SYS)] button.

3. Select the screen with “6 RPS PART” using the [CURSOR

(up/down)] buttons.

4. Press the [F2 (RPS)] button.

The “RPS PART” screen appears.

(Example1: PATCH screen)

(Example2: LEVEL screen)

5. Press the [F1 ( )] or [F2 ( )] buttons to select the screen

to be edited.

6. Press a keyboard pad to select the RPS part to be edited.

7. Specify a value using the [VALUE] dial or the [INC/

DEC] buttons.

PATCH (RPS Part Patch)

Select the Patch of the part.

Range:

- Patches

Preset P: A001 - 128

P: B001 - 128

P: C001 - 128

P: D001 - 128

P: E001 - 128

P: F001 - 128

P: G001 - 032

User U: A001 - 128

U: B001 - 128

- Rhythm sets

Preset P: A01 - 26

P: B01 - 14

User U: 01 - 20

LEVEL (RPS Part Level)

Sets up the volume level of the part.

Range: 0–127

PAN (RPS Part Pan)

Sets up localization of the part.

Range: L64–0–63R

KEY SHIFT (RPS Part Key Shift)

Sets up transposition of the part.

Range: -12–0– +12

REV LEVEL (RPS Part Reverb Level)

Sets up the reverb strength of the part.

Range: 0–127

DLY LEVEL (RPS Part Delay Level)

Sets up the delay strength of the part.

Range: 0–127

M-FX SW (RPS M-FX switch)

Specifies whether the Multi-effect function is to be used in

the part.

Range: OFF, ON, RHY

* RHY can only be used for RPS parts using a rhythm set. If a

part is set to RHY, M-FX effects are applied according to the

settings of the respective tones in the rhythm set. Activating

M-FX for a rhythm part causes the function to be applied to all

tones.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 215 216

Comments to this Manuals

No comments

Roland MC-307 Owner's Manual Page 40

Comments to this Manuals