Roland VM-C7200 Owner's Manual download pdf (Page 100)

Chapter 6 Mixing Procedure 2 (Output and Monitor)

Chapter 6 Mixing Procedure 2

(Output and Monitor)

■ To instantaneously lower the monitoring volume (DIM)

Press [DIM] to instantly lower the monitor volume to a pre-set level. Press the button

again to turn dimming off and return the monitoring volume to its normal level.

Pre-setting the dim level

1. Press MONITOR/PHONES [SOURCE SELECT] while holding down

[SHIFT].

This calls up the monitor screen.

2. Use CURSOR [UP] to select DIM/BALANCE/MONO.

fig.06-27

3. Use the V1 (DIM LEVEL) knob to set the level to which monitoring will

drop when dimming is activated.

With a setting of 100, dimming will leave the listening volume as is. Select a lower

number to cause the volume to be reduced when dimming is engaged. Dimming can

also be turned on or off by pressing [F1] (DIM).

■ Setting the monitor stereo balance

You can set the stereo left/right balance of the monitor signal.

Setting the monitor stereo balance

1. Press MONITOR/PHONES [SOURCE SELECT] while holding down

[SHIFT].

This calls up the monitor screen.

2. Use CURSOR [UP] to select DIM/BALANCE/MONO in the top section of

the display.

3. Set the monitor stereo balance using the V2 knob (BAL).

The stereo balance can be set from L63 to C to R63. A setting of L63 or R63 silences

the signal in the opposing channel.

■ Monitoring in mono

There are times when it can be useful to monitor in mono. Press [F2] (MONO) in Step

2 in “Setting the monitor stereo balance” above to mix the left and right sides of the

monitor signal equally into a single monaural signal.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 311 312

No comments

Roland VM-C7200 Owner's Manual Page 100