Roland VM-C7200 Owner's Manual download pdf (Page 86)

Chapter 6 Mixing Procedure 2 (Output and Monitor)

Chapter 6 Mixing Procedure 2

(Output and Monitor)

3. Use the master fader to set the cue bus master level.

fig.06-02

4. Call up the cue bus master stereo balance by pressing [CH PAN] (CUE

PAN) in the PARAM VIEW on Fader area while holding down [SHIFT].

The CH PAN button turns green.

5. Use the master fader to set the cue bus master stereo balance.

■ Reducing signal distortion (attenuator)

Press the master fader’s [CH EDIT] to set the master attenuators. These attenuators

help control the combined level of all of the signals coming into the main mix and

cue bus.

fig.06-03

Setting the MAIN OUT attenuator

1. Press [INPUT] or [MULTI IN] in the SECTION area.

2. Press the master fader’s [CH EDIT] and CURSOR [UP], in that order.

3. Turn [V1] (MAIN BUS ATT LEVEL) to set the MAIN OUT attenuator.

Setting the cue bus attenuator

1. Press [INPUT] or [MULTI IN] in the SECTION area.

2. Press the master fader’s [CH EDIT] and CURSOR [UP], in that order.

3. Turn [V3] (CUE BUS ATT LEVEL) to set the cue bus attenuator.

The master fader controls

the cue bus’s stereo balance

when [CH PAN] (CUE

PAN) is pressed. As a

result, it cannot be used for

setting levels while in this

operating mode.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 311 312

No comments

Roland VM-C7200 Owner's Manual Page 86