Roland VM-C7200 Owner's Manual download pdf (Page 181)

180

Chapter 8 Using the Internal Effects

Master Effect

What is master effect?

Besides ordinary FX-1 through FX-8 effects (FX-3 through FX-8 can be activated only when VS8F-2 is installed,

which is sold separately), a stereo effect of a different category referred to as Master Effect, is available. This is an

insertion effect specially developed for processing sounds output from MAIN OUT and MONITOR OUT of VM-

7100/7200 as well as for sounds output from PHONES (head set) of this equipment.

This Effect is useful, for example, to make final adjustment using “3-Band Dynamics” or “10-Band Parametric

Equalizer” while mixing down into an MD or a DAT as well as to simulate and check variations of sounds from

different speakers using “Speaker Modeling.”

Master Effect can be used only for sounds output from MAIN OUT of VM-7100/7200 or MONITOR OUT or

PHONES of the main equipment body.

Speaker Modeling

The effect algorithm is the same as ordinary speaker modeling. This effect works well when applied on sounds

output to MONITOR OUT. It is useful, for example, to check actual feel of a sound when output through different

speakers prior to mixing down.

10-Band Parametric Eqalizer

This is an equalizer that can freely change the cutoff frequency or the band width (Q) at 10 points. Furthermore,

as Expander and Compressor are linked, sufficient dynamics can be obtained while suppressing noise.

fig.08-89

Parameter (full name) Setting Function

BassCut (Bass Cut Filter): Cuts off undesired low sounds such as pop noise.

BCUT Sw (Switch) On, Off Turns the bass cut filter on or off.

Freq (Frequency) Thru, 20 - 2000 Hz Cuts off undesired low frequency band sounds such as pop

noise.

Input L

Output L

BASS CUT EXPANDER

COMPRESSOR

Input R

Output R

BASS CUT EXPANDER

COMPRESSOR

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 311 312

No comments

Roland VM-C7200 Owner's Manual Page 181