Roland VM-C7200 Owner's Manual download pdf (Page 45)

Chapter 3 Data Storage and Retrieval

Chapter 3 Data Storage

and Retrieval

5. Confirm selection.

After selection, press [F2] (CP/LOAD) to copy the contents of the library to the

channel delay. After this operation, the settings cannot be returned to their state

prior to copying.

Saving the current settings into a library

In the following descriptions, the delay library is again used as an example. (Since

Step 2 differs for the equalizer or channel library, refer to the column above.)

1. Make sure that [INPUT] or [MULTI IN] is selected under SECTION.

2. Call up the delay channel edit screen.

While holding down [CH EDIT] of the channel whose library is to be copied or

saved, press the status button marked [PREAMP GAIN] or [DELAY].

3. Press [COPY/LIBRARY].

This opens the channel delay library.

fig.03-02

In Step 4, INPUT or MULTI

IN can be selected instead

of U or P, and the V2 knob

can be used to select the

channel (1 to 24).

Proceeding to Step 5 (CP/

LOAD) in this state enables

the settings of the library to

e copied from the selected

channel to channel whose

[CH EDIT] is turned on.

How to call up the copy/save screen for each library

The following library screens can be called up by pressing [COPY/LIBRARY] in

Steps 2 and 3 on the previous page (press a desired channel in place of [CH EDIT]):

• Channel library

Press STATUS [CH VIEW] while holding down [CH EDIT].

• Channel delay library

Press STATUS [PREAMP GAIN] while holding down [CH EDIT].

Press STATUS [DELAY] while holding down [CH EDIT].

• Channel equalizer library

Press STATUS [EQ GAIN] while holding down [CH EDIT].

Press STATUS [HPF/LO] while holding down [CH EDIT].

Press STATUS [LO-MID] while holding down [CH EDIT].

Press STATUS [HI-MID/HI] while holding down [CH EDIT].

Screen operations are the same for all libraries.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 311 312

No comments

Roland VM-C7200 Owner's Manual Page 45