Roland VM-C7200 Owner's Manual download pdf (Page 194)

193

Chapter 10 Combining Recorders

■ Naming a locate point

Call a naming screen for locate points

1. While holding down [SHIFT], press [LOCATE] (EDIT).

A list of currently registered locate points will be displayed.

2. Select a point number you want to give a name.

You can select the name using the V1 knob (SELECT NUMBER).

3. Press [F3] (NAME) to open the screen.

fig.10-004

From this screen, you can change the locate point name selected in step 2 above (up

to 12 characters).

The screen operation is essentially the same as that required for naming an input

channel. For details, see “Naming input channels” (p. 83). Functionally, though,

there are the following differences.

• A short name (3 characters) is not available.

• The EZ naming function is not provided.

• Functions assigned to V1 to V6 (functions of the common name knobs remain

the same).

After specifying the name, press [F6] (EXIT) to return to step 2 above. The locate

point will be listed in the newly selected name.

■ Editing a locate point and pre-rolling

You can change the registered time of a currently registered locate point, or specify

its pre-roll time (described later).

Editing locate points

1. While holding down [SHIFT], press [LOCATE] (EDIT).

A list of locate points will be displayed.

fig.10-005

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 311 312

No comments

Roland VM-C7200 Owner's Manual Page 194