Roland VS-2000 User's Guide Page 217
- Page / 282
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
217
Chapter 17 Using Hard Drives
Chapter 17
4.
Turn on the power of the connected audio equipment.
5.
Raise the volume of the audio devices to appropriate
levels.
Connecting a Removable
External Hard Drive
It is possible to connect a removable external hard drive,
such as a Zip® drive, to the SCSI connector on the VS-1680.
Use the following procedure to connect an external
removable drive to the VS-1680.
fig.06-01
* Once the connections have been completed, turn on the power
to your various devices in the order specified. You can cause
malfunction and or damage to your speakers and other devices
if you turn on devices in the wrong order.
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
1.
Make sure that the power for all SCSI and audio devices
is turned off and connect the external SCSI device to the
25-pin SCSI port on the rear panel of the VS-1680.
WARNING: Only SCSI devices can be connected to the SCSI
port on the VS-1680. Connecting non-SCSI devices (including
parallel devices, which have a similar connector) can damage
the VS-1680.
2.
Turn on the power of the external drive.
3.
Turn on the power of the VS-1680 with the POWER
switch on the rear panel.
4.
Turn on the power of connected audio equipment.
5.
Raise the volume of the audio devices to appropriate
levels.
Initializing (Formatting) the Drive
A new drive, or a drive that was used by another device,
cannot be used on the VS-1680 as is. You must initialize the
drive so it can be used by the VS-1680. When a drive is
initialized, all existing data on that drive is erased—all of its
contents are irretrievably lost. Check any such drive you plan
to initialize to make sure it does not contain anything you do
not want deleted. Drives used with the VS-1680 cannot be
used on other devices, such as personal computers.
* If you accidentally delete data, that data cannot be restored to
its previous state. Roland Corporation assumes no liability
concerning such loss of data.
CAUTION: If you are using a drive or disk that has been
partitioned, you will not be able to choose a particular
partition to initialize. When you initialize a drive, the whole
drive and all of its partitions will be initialized at the same
time.
To initialize a new drive:
1.
Confirm that power to the drive and the VS-1680 are
turned on.
2.
If you are using a removable type drive insert a disk into
the drive.
3.
Press [PLAY (DISPLAY)].
4.
Hold [SHIFT] and press [F6 (UTILITY)]. The Utility
menu icon appears in the display.
5.
Press [F6 (DrIni)]. If “DrIni” does not appear in the
display above [F6], first press [PAGE] until “DrIni” is
displayed, and then press [F6 (DrIni)].
6.
Use [ ], [ ], [ ], and [ ] to move the
cursor, and use the TIME/VALUE dial to set each value.
- USER’S GUIDE 1
- IMPORTANT SAFETY INSTRUCTIONS 2
- SAVE THESE INSTRUCTIONS 2
- USING THE UNIT SAFELY 3
- IMPORTANT NOTES 5
- Table of Contents 10
- Preparations 17
- Front and Rear Panels 19
- Recorder Section 21
- Rear Panel 23
- Saving and Managing Data 25
- Mixer Section 27
- EFFECT bus and AUX bus 28
- Input Mixer 29
- Track Mixer 30
- Switching the Fader Functions 30
- Chapter 1 33
- Effects Section 34
- Chapter 2 Basic Operation 35
- Basic Navigation 36
- Setting the Internal Clock 37
- Before You Finish 38
- Restarting 39
- Chapter 3 Playback Operations 41
- Selecting a Playlist Display 42
- Playlist Display) 42
- Mixer Channel Display 43
- Changing Track Status 43
- Muting and Soloing 44
- Using Locators 45
- Using Markers 46
- Editing Marker Values 47
- Clearing Markers 47
- Other Ways to Move In a 48
- Store Your Song 48
- Protecting Songs (Song 49
- Protect) 49
- Selecting and Loading Songs 49
- Preparing for a New 51
- Tracks 9–16 cannot be used 52
- Parameters) 52
- About Recording Times 53
- If “Drive Busy!” is Displayed 53
- Connecting Instruments 55
- Recording to the Tracks 55
- Sources Assigned to Tracks 56
- Master Send Switch 57
- Master Send Pan 57
- Manual Punch-In/Punch-Out 59
- Auto Punch-In and Punch-Out 60
- Loop Recording 62
- Chapter 4 63
- Undo and Redo 64
- Track Bouncing 64
- Track Bouncing With Effects 66
- Recording a Digital Source 66
- Using the Metronome 67
- Saving Your Recordings 68
- Chapter 5 69
- Signal Flow (Busses) 70
- Signal Busses in the VS-1680 70
- Fader/Mute Button 73
- Determining Output 74
- Digital Out Connectors 75
- Direct Out Connectors 75
- Mixer Routing 76
- Input Mixer Default 76
- Assignment 76
- Stereo Link 77
- Linked Channels 78
- Linking the Faders of Two or 78
- More Channels (Fader Group) 78
- Using the Equalizer (EQ) 79
- Attenuation 81
- Copying Mixer Settings 82
- Mixer Scenes 83
- [F2 (EFX2)] Effect 2 Send 86
- [F3 (EFX3)] Effect 3 Send 86
- [F4 (EFX4)] Effect 4 Send 86
- [F5 (AUX)] AUX Send 86
- [F1 (Ef1In)] Effect 1 Insert 86
- [F2 (Ef2In)] Effect 2 Insert 87
- [F3 (Ef3In)] Effect 3 Insert 87
- F4 (EFX4)] Effect 4 Send 90
- [F6 (DOUT2)] DIGITAL OUT 2 94
- Chapter 6 95
- [F5 (AUX)] AUX Master Send 96
- Location of Effects 97
- Procedure for Using Effects 97
- Selecting Effect Patches 97
- Create a User Effect Patch 98
- Effect Types 99
- Connecting Effects 100
- Master Block 101
- Three Insert Effect Examples 102
- Connecting Effect Send-and 103
- Return Loops 103
- Send-and-Return Loops 104
- Effects Return Section 104
- Two Examples of Using Effect 104
- Using Effects While 105
- Recording 105
- Recording Insert Effects 106
- Recording an Effect Send-and 107
- Return Loop 107
- Recording Stereo Effects 108
- Three Important Reminders 108
- About Using Effects 108
- Chapter 8 EZ Routing 109
- Using EZ Routing Templates 121
- Chapter 9 Automix 123
- Using Automix 124
- Realtime Automix 124
- Snapshot Automation 126
- Automating Effect Changes 127
- Two Gradation Examples 128
- Updating Automix 129
- Understanding Fader Match 129
- Smooth Data Transitions 133
- Values (Shift/Expand) 134
- Erasing Automix Data on 136
- Specified Channels 136
- Erasing Automix Data 136
- Saving and Exiting Automix 137
- Track Editing 139
- Track Cut 140
- Track Move 141
- Start End To T 142
- Track Copy 143
- Track Insert 144
- Track Exchange 145
- Track Time Compression/ 146
- Expansion 146
- Chapter 10 147
- Track Name 148
- Track Import 149
- Phrase Editing 150
- (Phrase Split) 152
- Phrase Move 153
- Phrase Copy 153
- Phrase Trim In 153
- Phrase Trim Out 153
- Phrase New 154
- Naming Takes 155
- Deleting a Take (Delete) 156
- Editing Operations 157
- Steps for Track Editing 157
- Quick Editing 158
- Precision Editing 158
- Adjusting the Preview Length 159
- Setting Scrub Length 159
- Scrub Length (FROM) 160
- Scrub Length (TO) 160
- Step 2: Perform the Button 161
- Pushes to Complete the Edit 161
- Track Editing vs. Phrase 162
- An Editing Note of Caution 163
- Practical Editing Application 163
- SPECIAL SHORTCUT: 164
- Chapter 12 Song Editing 165
- Song Split 166
- Song Combine 167
- Chapter 13 Mastering 169
- Mastering Tracks Status 171
- Shortcuts 171
- Playing Back the Mastering 172
- Mixing Down While 173
- Inserting Effects 173
- To Prohibit Digital Copying 174
- Audio CD 175
- Creating a Master Stereo Mix 176
- Finalizing 176
- Assembling Multiple Songs 177
- Writing Songs to CD-R Discs 178
- CD Player Function 181
- Chapter 13 183
- Vari Pitch 185
- Numerics/ASCII 185
- Stereo Input 185
- Removing a Direct Current 186
- Offset from the MIX Bus 186
- Using the MONITOR Knob to 186
- Adjust Channel Panning 186
- Shut Down and Restart 187
- Synchronizing with MIDI 189
- Sequencers 189
- VS-1680 as the Master 190
- Synchronization Using the 190
- VS-1680 as the Slave 191
- Using MTC Offset 191
- Using the Sync Track (Master) 192
- Recording MIDI Clock Messages 193
- Synchronized Operation 193
- Using the Tempo Map 194
- Other Methods to Generate A 195
- Sync Track or Tempo Map 195
- Start Times 197
- Switching Track Status 198
- Switching Scenes 199
- Switching Effects 199
- Adjusting Effects 199
- Using an External MIDI 200
- Sound Source to Play the 200
- Metronome 200
- Device to Adjust the Mixer 201
- (Compu Mix) 201
- 30 MST Offset Balance 202
- 89 MST Offset Balance 202
- Preparations for Compu Mix 203
- Recording with Compu Mix 203
- MIDI Machine Control 204
- Common Terms 205
- Specific Software 206
- Applications 206
- Cubase VST 207
- Logic Audio 208
- Digital Performer 209
- Vision DSP 210
- VS-1680 as Master Device 211
- Chapter 17 Using Hard Drives 213
- Recovering Drive Space 214
- Song Erase 215
- Using External Hard Drives 216
- Connecting a Removable 217
- External Hard Drive 217
- Saving a Song to an External 218
- Song Copy Playable 219
- Song Copy Archives 220
- Drive Select 222
- Loading a Song from External 222
- Hard Drive Maintenance 223
- Drive Check 224
- Surface Scan 225
- Backup Options 226
- Chapter 18 CD Backup 227
- CD-R Backup 228
- CD-R Recover 229
- Before Backing Up to DAT 231
- Saving Song Data to DAT 232
- (Backup) 232
- Recovering Data from a DAT 233
- DAT recorder 234
- Digtal Out 234
- Digital Out 234
- Checking DAT Tape Contents 235
- DAT Backup Verification 236
- Chapter 19 237
- Drive Compatibility 239
- Song Import 239
- Song Export 241
- System Settings for Each 243
- Foot Switch Settings 244
- Global Settings 245
- Measure Display 246
- SCSI ID Number 246
- IDE Drive Switch 247
- Input Peak Level 247
- Previous/Next Switch 247
- Fan Control 248
- Play and Record Settings 249
- Mixer and System Initialize 249
- Alarm Clock 250
- Chapter 21 251
- Chapter 22 253
- Syncing Two VS-1680s with 254
- MTC and MMC 254
- Syncing a VS-1680 and a 255
- VS-880/880EX 255
- Device to Control the Mixer 256
- Synchronizing with Video 258
- Equipment 258
- Using External Effects Units 259
- Chapter 23 261
- How Do I Use Automix? 264
- How Do I Bounce Tracks? 265
- How Do I Bounce Tracks with 266
- Effects? 266
- Why Can’t I Hear My Effects? 266
- How Do I Use the Scrub and 267
- Waveform Display Features? 267
- Apparatus containing 281
- Lithium batteries 281
- Concerning Copyright 282
- Disclaimer of liability 282
- About the License Agreement 282
Related products and manuals for Musical Instruments Roland VS-2000
Musical Instruments Roland DR-3 User Manual
(121 pages)
(121 pages)
Musical Instruments Roland KF-7 User Manual
(20 pages)
(20 pages)
(100 pages)
Musical Instruments Roland 5000s User Manual
(195 pages)
(195 pages)
Musical Instruments Roland TD-3 User Manual
(76 pages)
(76 pages)
(16 pages)
Musical Instruments Roland KR117/115 User Manual
(228 pages)
(228 pages)
Musical Instruments Roland PK-5A User Manual
(14 pages)
(14 pages)
Musical Instruments Roland VS-880EX User Manual
(372 pages)
(372 pages)
Musical Instruments Roland GW-7 User Manual
(48 pages)
(48 pages)
© 2020, manymanuals.com. All rights reserved. | 1.067 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals