Roland VS-2000 User's Guide download pdf (Page 59)

Chapter 4 Recording Operations

Chapter 4

Blinking Red:

Record Ready mode

The track is ready to be recorded. When blinking red,

previously recorded material on the track will be heard.

Blinking Red/Orange:

Record Ready mode

The track is ready to be recorded and the source will be

heard. This occurs if the VS-1680 is in Record Ready and you

press PLAY, then press the flashing red status button.

Solid Red:

Record mode

Signal is being recorded on the track.

Green:

Play mode

The track will play back.

Off (unlit):

Mute

The track is muted.

Blinking Red/Green:

Play and Record mode

Indicates playback from and recording to the same track

simultaneously.

Using the Track STATUS Buttons

• To put a track directly into Record Ready status, press

and hold [REC] and press the track’s STATUS button

once.

• To put a track directly into Play mode, press and hold

[STOP] and press the track’s STATUS button once.

• While in playback, the STATUS button will only change

from green to unlit (mute) each time it is pressed.

• To assign an input to a track for recording, press and

hold the track’s STATUS button, and then press a

SELECT button for the input (or track) you want to

record.

Manual Punch-In/Punch-Out

Sometimes when listening to a recording, you may find

playing mistakes or lyrics that were sung incorrectly. You

may want to correct these sections without re-recording the

entire track, or without starting the song over. In such

instances, use the following procedure to re-record selected

parts. The switching from playback to recording while a song

is playing is called a “punch-in,” and the switching from

recording back to playback is called a “punch-out.”

Manual Punch-In Using the RECORD

Button

Use the transport control buttons to punch in and out.

fig.03-07

Hold down [REC] and press the STATUS button for the

track you wish to re-record.

Press [ZERO] to return to the beginning of the song.

Press [PLAY] to begin song playback. At this point, you

will hear the performance that was already recorded on

the track.

Press the STATUS button. The indicator alternately

blinks red and orange. Confirm that you can hear the

source you want to record in the monitors or

headphones.

During playback of the song, each time the STATUS

button is pressed, you will alternately hear the

previously recorded track, and then the source (input). If

necessary, use the input sensitivity knob to adjust the

input level of the source so it matches the level of the

recorded track.

Once you have adjusted the input sensitivity, press

[STOP].

Move to the section of the song where you wish to re-

record.

Press [PLAY] to begin playback of the song.

When you reach the exact point in the song you wish to

re-record, press [REC]. The VS-1680 goes into Record

mode, and begins recording the new performance.

10.

When you have finished recording, press [REC] once

more to punch-out.

11.

Each time the [REC] button is pressed, the recorder

alternately punches in and out. You can repeat this

procedure for any tracks you wish to fix.

12.

Press [STOP] to stop the song.

13.

To listen to the results of the punch-in and punch-out,

press [ZERO] to return to the beginning of the song and

press [PLAY].

Time

Recording

Playback

Start Punch-in Punch-out Stop

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 281 282

Comments to this Manuals

No comments

Roland VS-2000 User's Guide Page 59

Comments to this Manuals

Related products and manuals for Musical Instruments Roland VS-2000