Roland VS-300 User Manual download pdf (Page 112)

5-7 If an Error Message Appears

Chapter 5 What to Do If

110

If this message appear even though you are using the ma-

chine within the recommended temperature range, then

check to make sure the voltage switches are set to the cor-

rect voltage for the region where you're using the machine.

[MOTOR ERROR TURN OFF POWER]

A motor error occurred.

Operation cannot be continued. Switch off the sub power.

Next, eliminate the cause of the error, then immediately

switch on the sub power. If the machine is allowed to stand

with the error uncorrected, the print heads may dry out and

become damaged.

This error may be caused by such factors as a mistake in

loading the media, a media jam, or an operation that pulls

the media with excessive force.

[TEMPERATURE IS TOO LOW]

The temperature of the location where the machine

is installed has fallen below the ambient tempera-

ture at which the machine can operate.

Operation cannot be continued. Switch off the sub power.

Bring the installed location to a temperature at which op-

eration is possible (20 to 32 ˚C), then turn on the power.

[TEMPERATURE IS TOO HIGH]

The temperature of the location where the machine

is installed has risen above the ambient tempera-

ture at which the machine can operate.

Operation cannot be continued. Switch off the sub power.

Bring the installed location to a temperature at which op-

eration is possible (20 to 32 ˚C), then turn on the power.

[HEATER VOLTAGE SETTING ERROR]

The heater temperature experienced a sudden rise

because the settings for the voltage switches are in-

correct.

Operation cannot be continued. After switch off the sub

power and the main power, make the correct settings for

the voltage switches. For information on how to make the

settings, refer to "Setup Guide."

[CANCELED FOR PROTECTING MOTOR]

Continuous operation made the pump motor be-

come hot, and so operation was paused.

Press any key to clear the error. Allow the machine to stand

for approximately 40 minutes, then resume operation.

[AVOIDING DRY-UP TURN OFF POWER]

The print heads were forced to standby position to

prevent them from drying out.

Operation cannot be continued. Switch the sub power off,

then back on. Opening the front cover while printing is in

progress causes an emergency stop. Never allow the print

heads to stand in this state.

[CARRIAGES ARE SEPARATED]

The cutting carriage and the printing carriage were

improperly disconnected.

A problem such as a media jam occurred, impeding cor-

rect operation. Operation cannot be continued. Switch the

sub power off, then back on.

[SERVICE CALL ****]

An unrecoverable error occurred, or part replace-

ment that must be performed by a service techni-

cian is required.

Note the number displayed, then switch off the sub power.

After you switch off the power, inform your authorized

Roland DG Corp. dealer or Roland DG Corp. service cen-

ter of the number that appeared on the display.

Downloaded From ManualsPrinter.com Manuals

1 ... 111 112 113 ... 122

Comments to this Manuals

No comments

Roland VS-300 User Manual Page 112

Comments to this Manuals

Related products and manuals for Print & Scan Roland VS-300