When C1 or C2 is selected , any of the following four functions can be assigned
“
-” in the Display actually shows 1 or 2 depending which of or is pushed
shows the value set in the Patch Memory
Adjusts the volume balance of the Upper
and Lower.
Raising the Knob increases the Upper
volume, and lowering the Knob increases
Adjusts the Portamento Time.
Raising the Knob
makes longer
Portamento Time
Adjusts the volume within the range of the
maximum volume
Volu
me. Raising the Knob raises the
volume, reaching the maximum volume. At
the same time, the MIDI volume of the
Upper and the Lower change.
Controls the MIDI messages of the Upper
or Lower section
Refer to “MIDI” on page xx.
• With the new firmware, once C1 and C2 are assigned two different Factors, they will be controllable by C1 and
C2 sliders respectively, in real time.
*When PEDAL SWITCH is selected, any of the following four functions can be assigned.
Pressing the pedal changes the bank and
the number of the Patch Memory.
A1 → A2 ........ AB → B1 → B2 ........
Turns the Portamento ON or OFF.
Turns the Chase Play Function (p. xx)
ON or OFF.
Turns ON or OFF the Hold Effect of the
Upper and/or the lower section.
**
**
**
**
**
**
**
**
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 13 of 53
Comments to this Manuals