Roland JX-10 Owner's Manual download pdf (Page 39)

3. Error Messages

If the Display reacts differently from what is said in the manual, (we call this error message), it is most likely that

you have taken a wrong operation. The following shows the error messages of the JX-10 and explains how to

correct them.

You have tried to take writing procedure without setting the relevant

Protect Switch to the OFF position. When the Voice Memory Switch

on the JX-1 0 is set to the INT position, the Protect Switch on the

JX-1

0 should be set to the OFF, and when it is in the CART

position, the Protect Switch on the Cartridge should be set to the

OFF position.

When the Voice Memory Switch is set to the CART position, in other

words, when the JX-10 is in the Cartridge mode, this error message

may be seen if the cartridge is not securely connected. Remove the

cartridge then securely connect it in the correct direction (with the

Protect Switch side facing upward).

This error message is indicated when you have tried to write Patch

Memory or Tone data, and vice versa. Change the cartridge to the

correct one.

However, if you wish to clear the data on the cartridge currently

connected and use it for different data, repeat the same writing

procedure you have taken twice more. The Display will show

MISMATCH again at the first time, but just carry on, writing will be

done at the second time .

This error message is shown when you have tried to write Patch

Memory and Tone data onto the M-16C which does not have the

capacity to store it. Change the cartridge to the M-64C.

This error message is shown when you have tried to write the edited

Tone to the Tone Number other than 1 to 50. Tone numbers from

51 to 100 are ROM, therefore cannot be rewritten.

When using the Memory Cartridge of the JX-8P, this error message

is seen by assigning the Tone numbers other than 1 to 32.

When this is shown several times, the JX-10 is in trouble. You need

to have it repaired.

4. JX-10 RESET

To reset JX-10 MIDI, Arpeggiator and Controls to their default values (Patches and Tones will remain untouched)

press:

• <WRITE> +  LOWER + UPPER when powering the JX-10.

Keep in mind: no indication that reset is done.

MEMORY PROTECTED

INSERT CARTRIDGE

MISMATCH

NOT M-64C

SELECT NO. 1-50

SELECT NO. 1-32

MEMORY ERR

Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM

Pag. 39 of 53

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 52 53

Comments to this Manuals

No comments

Roland JX-10 Owner's Manual Page 39

Comments to this Manuals

Related products and manuals for Digital pianos Roland JX-10