2 – CONNECTIONS
1. Total Mix Output Jack
Connect this to the amplifier. To make the best use of the JX-10, use the amplifier and speaker of wide frequency
response and dynamic range such as keyboard amplifier or a studio amplified pair of monitors.
2. Parallel Output Jacks
These are also for connecting amplifiers. Different ways of connections will make various sound effects.
The following shows several different ways for using the Output Jacks.
Mixed output of Upper and Lower
B: Monaural Output of Upper
C: Monaural Output of Lower
Stereo Output of Upper and Lower
When the JX-10 is set to the Whole mode, connecting a stereo amplifier to the UPPER MONO and LOWER
MONO of the Parallel Output Jacks (output jacks C and D shown in the above picture) will cause the sounds to
be output irregularly through L or R. It is normal for this unit to behave like this.
3. Output Level Switch
Use this switch to select the output level depending on the amplifier connected to the Total Mix Output.
* This switch does not work on the signal sent from the Parallel Output Jack.
4. Headphones Jack
Connect stereo headphones to this jack.
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 5 of 53
Comments to this Manuals