Roland JX-10 Owner's Manual download pdf (Page 37)

c. Copying a Tone

A Tone in the JX-10’s internal memory can be copied onto the Memory Cartridge and vice versa.

1) Saving a Tone to the Cartridge

1. Set the Protect Switch on the Memory Cartridge to the OFF position.

2. Set the Voice Memory Switch to the INT position.

3. Call the Patch Memory that contains the Tone you wish to copy.

• In the Dual or Split mode, the Tone with a dot is copied.

• In the Upper whole mode, the Tone of the Upper section is copied.

4. Push the WRITE Button

The Display will respond with:

5. Push the PATCH of the Edit Buttons.

6. Set the Voice Memory Switch to the CART position.

7. Using the Ten Keys, assign the new location (=Tone number) where you wish the Tone you called in the step 3

to be copied.

8. Push the ENTER Key.

9. Return the Protect Switch on the Memory Cartridge to the ON position.

2) Coping a Tone in the Cartridge to the JX-10’s internal memory

1. Set the Protect Switch on the JX-10 to the OFF position.

2. Set the Voice Memory Switch to the CART position.

3. Call the Patch Memory that contains the Tone you wish to copy.

• In the Dual or Split mode, the Tone with a dot is copied.

• In the Upper whole mode, the Tone of the Upper section is copied.

4. Push the WRITE Button

The Display will respond with:

5. Push the TONE of the Edit Buttons.

6. Set the Voice Memory Switch to the INT position.

7. Using the Ten Keys, assign the new location (=Tone number) where you wish the Tone you called in the step 3

to be copied.

8. Push the ENTER Key.

9. Return the Protect Switch on the JX-10 to the ON position.

Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM

Pag. 37 of 53

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 52 53

No comments

Roland JX-10 Owner's Manual Page 37