99
00
When the LFO output is modulating the DCO, this
parameter is used to adjust the depth of the
modulation. For vibrato effect, select “SINE” with
the LFO Depth LFO Waveform
When the ENV output is modulating the DCO, this
parameter is used to adjust the depth of the
modulation.
DCO 1 Xmod
XMOD
SNC2
SNC1
OFF
• XMOD:
The pitch is determined by DCO-1, and
the harmonic contents by DCO-2. The waveform
is determined by the DCO-2’s synchronization to
DCO-1
• SNC2: Both SYNC 1 and X MOD work together.
• SNC1: DCO-1 and DCO-2 affect
harmonic contents and waveform
• OFF: Each DCO-1 and DCO-
2 can have
different pitch and waveform
DCO 2 FTUN
+50
-50
The frequency (pitch) of the DC0-2 can be adjusted
with this parameter.
*Variable range ±50 cent
DCO DYNA
3
2
1
off
When the DCO's pitch is controlled by the ENV, and
the amount of the ENV is controlled by Dynamics
(Key Touch), this parameter adjusts the sensitivity of
Key Touch.
(Note 1)
DCO MODE -1
-2
-2
-2
This selects the polarity of the Envelope curve.
Normally, is used. In mode, ADSR
pattern will be inverted.
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 23 of 53
Comments to this Manuals