Roland XP-80 Owner's Manual download pdf (Page 82)

HF Damp

Adjust the frequency above which the reverberant sound

will be cut. As the frequency is set lower, more of the high

frequencies will be cut, resulting in a softer and more muted

reverberance. If you do not want the high frequencies to be

cut, set this parameter to BYPASS.

Low Gain

Adjust the gain of the low frequency range.

High Gain

Adjust the gain of the high frequency range.

Balance (Effect balance) #

Adjust the volume balance between the direct sound and the

processed sound.

Level (Output level)

Adjust the output level.

25: GATE-REVERB

Gate Reverb is a special type of reverb in which the reverber-

ant sound is cut off before its natural length.

Type (Gate reverb type)

Select the type of reverb.

NORMAL

: conventional gate reverb

REVERSE

:backwards reverb

SWEEP1

: the reverberant sound moves from right to left

SWEEP2

: the reverberant sound moves from left to right

Pre Delay (Pre delay time)

Adjust the time delay from when the direct sound begins

until the reverb sound is heard.

Gate Time

Adjust the time from when the reverb is heard until when it

disappears.

Low Gain

Adjust the gain of the low frequency range.

High Gain

Adjust the gain of the high frequency range.

Balance (Effect balance) #

Adjust the volume balance between the direct sound and the

processed sound.

Level (Output level) #

Adjust the output level.

26: OVERDRIVE

➞

CHORUS

This effect connects an overdrive and a chorus in series.

OD Drive

Adjust the degree of overdrive distortion. The volume will

change together with the degree of distortion.

OD Pan (Output pan) #

Adjust the stereo location of the overdrive sound. L64 is far

left, 0 is center, and 63R is far right.

Chorus Pre Delay (Chorus pre delay time)

Adjust the time delay from when the direct sound begins

until the chorus sound is heard.

Chorus Rate

Adjust the modulation speed of the chorus effect.

Chorus Depth

Adjust the modulation depth of the chorus effect.

Chorus Balance #

Adjust the volume balance between the overdrive sound

that is sent through the chorus and the overdrive sound that

is not sent through the chorus. With a setting of “D100: 0E,”

only the overdrive sound will be output. With a setting of

“D0: 100E,” only the overdrive sound that is sent through

the chorus will be output.

Level (Output level)

Adjust the output level.

27: OVERDRIVE

➞

FLANGER

This effect connects an overdrive and a flanger in series.

OD Drive

Adjust the degree of overdrive distortion. The volume will

change together with the degree of distortion.

OD Pan (Output pan) #

Adjust the stereo location of the overdrive sound. L64 is far

left, 0 is center, and 63R is far right.

Flanger Pre Delay (Flanger pre delay time)

Adjust the time delay from when the direct sound begins

until the flanger sound is heard.

Flanger Rate

Adjust the modulation speed of the flanger effect.

Flanger Depth

Adjust the modulation depth of the flanger effect.

Flanger Feedback (Flanger feedback level)

Adjust the proportion (%) of the flanger sound that is fed

back into the effect. Negative (-) settings will invert the

phase.

Chorus

Overdrive

Flanger

Overdrive

Chapter 3. Creating your own sounds

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 243 244

Comments to this Manuals

No comments

Roland XP-80 Owner's Manual Page 82

Comments to this Manuals

Related products and manuals for Musical Instruments Roland XP-80