VCA (Voltage Controlled Amplifier)/Chorus
After filtered in the VCF, the signal is fed to the VCA where the volume (amplitude) of the sound is controlled
.
99
00
This is to adjust the volume level, and can be
effectively used in the writing mode.
If it is set too high, sound may be distorted.
VCA MODE
ENV2
GATE
This is to select whether to control the VCA by the
signal from the ENV-2 ( ) or by the Gate signal (
).
VCA DYNA
3
2
1
This parameter determines the sensitivity of the Key
Touch (Dynamics effect). (Note 1)
2
1
OFF
1: Expansive Chorus effect is obtained.
2: Rich Chorus effect is obtained
LFO (Low Frequency Oscillator)
This oscillator generates extremely low frequency, so produces a vibrato or growl effect by controlling the DCO or
VCF
LFO WF
SINE
SQUAR
RAND
This is for selecting the LFO output waveform:
LFO DELAY
99
00
This sets the time needed for the modulation by the
LFO to start
LFO RATE
99
00
This sets the rate (frequency) of the LFO
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 26 of 53
Comments to this Manuals