Roland VS-300 User Manual download pdf (Page 36)

Chapter 2 Operation

2-4 Starting Output

Getting Ready to Receive Data from a Computer

When you have finished loading media and making the temperature settings for the print heater and dryer, then follow

the steps below. This procedure enables the machine to receive data from the computer and perform output.

Note, however, that when you want to perform only cutting, operation that differs from the following procedure

is required.

☞ p 38 "Performing Cutting"

Procedure

➊

Close the front cover (making the [SET UP] light come on).

➋

Wait until light stops flashing and stays steadily lit.

➌

Make sure you are at the top menu.

If you are not at the top menu, press .

Printing Is Not Possible in These Situations

➢The machine does not run when the front cover is open. Also, never open it when printing is in progress. Doing

so interrupts printing.

➢Data from the computer is not accepted when the [SET UP] light is dark.

➢Printing does not start until light comes on.

➢Data from the computer is not accepted when you are not at the top menu.

Points Which Must Be Observed

➢Be sure to set the media clamps. Otherwise the edges of the media may warp and catch on the print heads.

➢During printing, never touch the media that's already been discharged. Doing so may obstruct media feed or

cause the media to rub against the heads, which may result in a paper jam or damage to the heads.

Top menu

Flashing

Steadily lighted

W 500mm

Downloaded From ManualsPrinter.com Manuals

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 121 122

No comments

Roland VS-300 User Manual Page 36