17
Chapter 1 Playing Sounds
Chapter 1
Adjusting the Input Level
Use the INPUT LEVEL knob to adjust the input level to suit
your guitar.
fig.01-0060
1. Play your guitar at the maximum loudness that you will
produce in normal playing.
2. Adjust the INPUT LEVEL knob until the PEAK
indicator lights briefly.
* The PEAK indicator will light 6 dB before clipping level (the
level where distortion begins).
* If the input level is too high, the GT-PRO will not produce the
desired effects.
When using the GT-PRO with different guitars, you can
conveniently adjust the input levels for each patch with
the INPUT LEVEL knob and adjust for the volume
differences between each guitar with SYS: Input Level.
Refer to “Adjusting the Tone of the Sounds Input to the
GT-PRO (Input Level/Input Presence)” (p. 97)
Adjusting the Output Level
Adjust the GT-PRO’s output level.
fig.01-0070
• The level of the output from the MAIN OUT jacks is
adjusted with the MAIN volume knob.
Adjusting the SUB OUT Output Level
• The level of the output from the SUB OUT jacks (1/4”
phone type) is adjusted with the SUB volume knob.
* The output from the SUB OUT (XLR type) connector is set
at a fixed level, regardless of the position of the SUB volume
knob.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
The output from the PHONES jack is a mix of the output
from the MAIN OUT and SUB OUT.
When using headphones, use both the MAIN and SUB
knobs as required to adjust the volume level.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Selecting the MAIN OUT Output
Device (Amp) (Main Output Select)
Select the type of device connected to the MAIN OUT jack.
fig.01-0080
1. Press [OUTPUT SELECT].
The Main Output Select settings screen appears.
fig.01-0090d
2. Turn the PATCH/VALUE dial to select the type of
device connected to the MAIN OUT jack.
3. Press [EXIT] to return to the Play screen.
Value Explanation
JC-120
Use this setting when connecting to Ro-
land’s JC-120 guitar amp.
SMALL AMP
Use this setting when connecting to small
guitar amp.
COMBO AMP
Use this setting when connecting to the
guitar input of a combo amp other than
the JC-120 guitar amp (where the amp
and speaker or speakers are combined in
a single unit).
* Depending on you guitar amp, you may be able to obtain good
results with the “JC-120” setting.
STACK AMP
Use this setting when connecting to the
guitar input of a stack-type guitar amp
(where the amp and speaker or speakers
are separated).
JC-120 Return
Use this setting when connecting to RE-
TURN of a JC-120.
COMBO Return
Use this setting when connecting to RE-
TURN with a combo amp.
STACK Return
Use this setting when connecting to RE-
TURN of a stack amp or rack mounted
power amp.
Set to STACK Return also when using a
guitar power amp and speaker cabinet
combination.
LINE/PHONES
Use this setting when using headphones
or when connecting to a multi-track re-
corder for recording.
* When using the speaker simulator, set this to LINE/PHONES.
12
3
Comments to this Manuals