Roland GT-PRO Owner's Manual download pdf (Page 41)

Chapter 4 Introduction to Effects and Parameters

Chapter 4

UV (Uni-V)

Although this resembles a phaser effect, it also provides a

unique undulation that you can’t get with a regular phaser.

RM (Ring Modulator)

This creates a bell-like sound by ring-modulating the guitar

sound with the signal from the internal oscillator. The sound

will be unmusical and lack distinctive pitches.

SG (Slow Gear)

This produces a volume-swell effect (“violin-like” sound).

DF (Defretter)

This simulates a fretless guitar.

Parameter/

Range

Explanation

Rate

0–100,

BPM –BPM

Adjusts the rate of the Uni-V effect.

* When set to BPM, the value of each parameter will be set according to

the value of the Master BPM (p. 55) specified for each patch. This makes

it easier to achieve effect sound settings that match the tempo of the

song (synchronizing the cycle to one-half or one-fourth of the BPM

when the set cycle rate is increased).

When setting to BPM, press PARAMETER [ ] several times to

display the Master BPM settings screen.

Depth

0–100 Adjusts the depth of the Uni-V effect.

Level

0–100 Adjusts the volume.

Parameter/

Range

Explanation

Mode

Normal, Intelligent

This selects the mode for the ring modula-

tor.

Normal

This is a normal ring modulator.

Intelligent

By ring-modulating the input signal, a bell like sound is created. The

intelligent ring modulator changes the oscillation frequency accord-

ing to the pitch of the input sound and therefore produces a sound

with the sense of pitch, which is quite different from “Normal.” This

effect does not give a satisfactory result if the pitch of the guitar

sound is not correctly detected. So, you must use single notes, not

chords.

Frequency

0–100

Adjusts the frequency of the internal oscilla-

tor.

Effect Level

0–100 Adjusts the volume of the effect sound.

Direct Level

0–100 Adjusts the volume of the direct sound.

Parameter/

Range

Explanation

Sens

0–100 Adjusts the sensitivity of the slow gear.

When it is set to a lower value, the effect of the slow gear can be ob-

tained only with a stronger picking, while no effect is obtained with

a weaker picking. When the value is set higher, the effect is obtained

even with a weak picking.

Rise Time

0–100

Adjusts the time needed for the volume to

reach its maximum from the moment you

begin picking.

Parameter/

Range

Explanation

Tone

-50–+50

Adjusts the amount of blurring between the

notes.

Sens

0–100

This controls the input sensitivity of the de-

fretter.

Attack

0–100 Adjusts the attack of the picking sound.

Depth

0–100 This controls the rate of the harmonics.

Resonance

0–100

Adds a characteristically resonant quality to

the sound.

Effect Level

0–100 Adjust the volume of the defretter sound.

Direct Level

0–100 Adjust the volume of the direct sound.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 41

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO