Roland GT-PRO Owner's Manual download pdf (Page 70)

Chapter 6 Using Pedals to Control the Effects

fig.06-0240

* When using a foot switch or other on/off switching controller

as the source, leave these at “Lo: 0” and “Hi: 127.” With

certain settings, the value may not change.

Internal Pedal System

The GT-PRO features a function called Internal Pedal system.

This function assigns specified parameters to a virtual EXP

pedal (the internal pedal), providing an effect automatically

that changes volume and tone in real time just the way an

expression pedal functions.

The Internal Pedal system features the following two

functions, allowing you to set “Source” for each assign

number (1–12) of the Assign.

❍ Internal Pedal

❍ Wave Pedal

* When the Internal Pedal or the Wave Pedal is used, set the

ASSIGN Source Mode to Normal.

Internal Pedal

With the trigger you have set, the assumed EXP pedal starts

working. If you have set “Internal Pedal” to “Source,” set the

following parameters.

Off

Center

value

0408060

127

Act.Range

Parameter/

Range

Explanation

Trig (Trigger)

fig.06-0250d

see below

This sets the trigger that activates the virtual

EXP pedal.

PatchChange

This is activated when a patch is selected.

EXP PEDAL 1

This is activated when the EXP pedal connected to the EXP PEDAL

1 jack is depressed.

CTL PEDAL 1

This is activated when the foot switch connected to the CTL 1 jack is

depressed.

CTL PEDAL 2

This is activated when the foot switch connected to the CTL 2 jack is

depressed.

EXP PEDAL 2

This is activated when the EXP pedal connected to the EXP PEDAL

2 jack is depressed.

CTL PEDAL 3

This is activated when the foot switch connected to the CTL 3 jack is

depressed.

CTL PEDAL 4

This is activated when the foot switch connected to the CTL 4 jack is

depressed.

FC-200 EXP

When an FC-200 is connected, this is activated when the FC-200’s

EXP pedal is depressed.

* Control Change No. 7 (CC#7) is used.

FC-200 CTL

When an FC-200 is connected, this is activated when the FC-200’s

CTL pedal is depressed.

* Control Change No. 80 (CC#80) is used.

MIDI CC#1–31,64–95

This is activated when the value of the Control Change messages

(CC#01–31, 64–95) from an external MIDI device exceeds the middle

value.

Time

fig.06-0260d

0–100

This controls the time needed for the as-

sumed Expression pedal to move from the

returned (lifted) position to the depressed

(lowered) position.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 163 164

Comments to this Manuals

No comments

Roland GT-PRO Owner's Manual Page 70

Comments to this Manuals

Related products and manuals for Supplementary music equipment Roland GT-PRO