Roland GT-PRO Owner's Manual download pdf (Page 18)

Chapter 1 Playing Sounds

Selecting the SUB OUT Output

Device (Amp) (Sub Output Select)

Select the type of device connected to the SUB OUT jack/

connector.

fig.01-0081

1. Press [OUTPUT SELECT].

2. Press PARAMETER [ ] [ ] so that

“SUB: Output Sel.” is displayed.

fig.01-0100d

3. Turn the PATCH/VALUE dial to select the type of

device connected to the SUB OUT jack/connector.

* The types of devices that can be selected are the same as those

in Main Output Select.

4. Press [EXIT] to return to the Play screen.

Turning Off the Power

1. Before turning off the power, confirm the following.

• Is the volume on the GT-PRO, your amp, and all other

connected devices turned down to the minimum level?

2. Turn off the power to any external effects processors,

then to the guitar amp (power amp) and other devices.

3. Turn the GT-PRO’s power off.

* If you need to turn off the power completely, first turn off the

POWER switch, then unplug the power cord from the power

outlet. Refer to “Power Supply” (p. 5).

132

To derive the maximum performance from the GT-PRO,

be sure to make the correct setting for Main Output

Select and Sub output Select, the one that’s most suitable

for your setup.

* The speaker simulator (p. 28) is enabled only when Main

Output Select/Sub Output Select is set to LINE/

PHONES.

* You cannot change the tone with Main Output Select/

Sub Output Select when PREAMP/SPEAKER On/Off

(p. 28) is set to Off.

Guitar Tuning

You can use the GT-PRO’s built-in “tuner function” to

tune your guitar.

For instructions on using this function, refer to “Tuning

the Guitar (Tuner/Bypass)” (p. 101).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 163 164

No comments

Roland GT-PRO Owner's Manual Page 18