Roland VM-C7200 Owner's Manual download pdf (Page 81)

100

Using EZ Routing Templates

Using TASCAM types

The basic steps are mostly the same as formerly mentioned (ADAT), but

there are some exceptions.

• Use a TDIF-1 cable and SYNC cable to connect your TASCAM to

DIF-AT.

(Connect the SYNC cable to the REMOTEIN/SYNC IN socket on the

TASCAM.)

• In Step 3, set “WORD CLOCK SOURCE” to the TASCAM (“MULTI

1-8”, “MULTI 9-16”, or “MULTI 17-24”).

• In Step 5, set “DIF-AT CONTROL TARGET” to “DA-88”.

• As formerly mentioned, read the instructions in the manual of the

connected recorder. If you are planning to use several TASCAMs in

synchronization, you must beforehand set the ID of each recorder.

To Send Signals to a FlexBus

1. Press FLEX BUS [1]-[6] – or hold down [SHIFT] to select [7]-[12] – to

select the Flex Bus to which you want to send the signals.

2. Use the channel faders to adjust each channel’s send level to the Flex

Bus.

3. Use the [MASTER] fader to adjust the Flex Bus’ overall level.

4. Repeat Steps 1-3 to assign signals to other Flex Busses.

8 Track Digital Recording

The 8 Track Digital Recording EZ Routing template sends your signals to

Flex Busses routed to an R-BUS, a stream of digital data containing eight

separate channels of digital audio. Each of these R-BUS channels is routed

to the corresponding track of an R-BUS connected 8 track digital recorder.

R-BUS 1: Electric Bass (Ch 14)

R-BUS 2: Lead Guitar (Ch 15)

R-BUS 3: Acoustic Guitar (Ch 16)

R-BUS 4: Chorus 1 (Ch 17)

R-BUS 5: Chorus 2 (Ch 18)

R-BUS 6: Chorus 3 (Ch 19)

R-BUS 7: Lead Vocal (Ch 20)

R-BUS 8: Lead Vocal spare track (Ch 20)

The 8 Track Mixdown Procedure

During mixdown, you can use MTC to play back tracks recorded on your 8

track digital recorder while your MIDI sequencer runs in sync with the

system. Control the MIDI-sequenced materials at [INPUT] channels, and the

live elements on the digital recorder at [MULTI IN] channels.

Owner’s Manual “Setting a

channel’s send level and

send point to Flex Buses”

(p.72)

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 99 100

Comments to this Manuals

No comments

Roland VM-C7200 Owner's Manual Page 81

Comments to this Manuals

Related products and manuals for Processors Roland VM-C7200