Roland VM-C7200 Owner's Manual download pdf (Page 52)

Using On-Board Effects

Press CURSOR [UP] [DOWN] to select the FX field.

FX-1-3 are located in the upper field, FX-4-6 in the middle, and FX-7-8 in the

lower. If you have not installed an optional VS8F-2, you can only select FX-

1 or FX-2.

Press [F2], [F4], or [F6] to “EDIT” the effect.

The “EFFECT (1-8)” editing display appears.

Press [PAGE DOWN] to go to the “ASSIGN” page.

At this point, you set the insertion point of the effect.

fig.216

Press CURSOR [UP] [DOWN] to select L or R.

Turn [V4](SEND LEVEL) to adjust the level to be sent into the

effect, and [V5](RETURN LEVEL) to adjust the effect’s output

level.

The setting’s range is 0 to 127, with no boost or cut applied to the gain (0dB)

at 100.

Turn [V2](POSITION) to select “SEND/RTN”

The effect is automatically assigned to its like-numbered Flex Bus.

Flex Bus channel to which an effect is inserted.

Flex Bus channel to which an effect is not inserted.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 99 100

No comments

Roland VM-C7200 Owner's Manual Page 52