Roland VM-C7200 Owner's Manual download pdf (Page 77)

Using EZ Routing Templates

Make your connections as shown on the left.

• Use MIDI cables to connect the system to your MIDI devices (sound

module, sampler, digital multi-track recorder, etc.).

• You can set up as many as four monaural monitor outputs for your

performers. Connect their headphones or monitor amplifiers to FLEX

BUS OUTs 9-12.

• Route any guitar or electric bass through direct boxes or a compact

effect processor connected to the system input.

Turn on the power to your devices in the following sequence.

1. Digital multi-track recorder

2. Digital devices (DAT, MD recorder, etc.)

3. Analog devices (instruments, sound modules, effects processors,

microphones, electric guitars, etc.)

4. Mixing processor

5. Mixing console

6. Audio equipment (amplifiers, speakers)

Select the EZ Routing template for 8 Track Recording With

MIDI Sound Modules.

1. Press [EZ ROUTING], and then press [F1](TEMPLATE)

2. Turn [V1](SELECT GROUP) to select group “P”, and then turn

[V2](SELECT NUMBER) to select “P000: MIDI+8TrREC”.

3. Press [F2](CP/LOAD).

• The “MIDI+8TrREC” template has been recalled.

Configure your MIDI devices to be synchronized to the

system.

• As set at the factory, the console is set to transmit MTC (MIDI Time

Code) as the master timing reference. Set your external MIDI slave

devices to sync to MTC.

• Consult your MIDI devices’ documentation to learn how to set them

up for external MTC synchronization.

QUICK START “Turning

On the Power” (p.10)

Owner’s Manual “Calling

Up Stored Connections (EZ

Routing)” (p.59)

Owner’s Manual “Using

with MIDI Devices” (p.222)

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 99 100

No comments

Roland VM-C7200 Owner's Manual Page 77