Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 110)

110 MaxMotion for Machines

sent out to the machine and will override the settings at the machine.

Layout

The Layout parameters are used to position your job exactly where you

want it on your material. By using base line and left margin you can

place the lower left corner of your job anywhere within your material

dimensions.

Current job / Auto Centering

The current job parameters are used to automatically center your job to

the material size showing. You can center the job by clicking on the

boxes for Top/Bottom centering and Left/Right centering. Please, note

that as you click on the box for Top/Bottom, the baseline box in the

Layout menu will be grayed out. Also, the dimension value in the

baseline box may change to a value for centering the job. A grayed out

value cannot be edited. Similarly, the Left Margin box in the Layout

menu will be grayed out when you click on the box for Left/Right

centering.

Speed

The speed parameters for rout speed and Z feed will be picked up from

the Material menu and displayed. The values are in percentages and can

be changed at the last minute here in the final screen before sending the

file to the machine.

Cutter

All the parameters are picked up from the Material menu and dis-

played. Any of the values can be changed here.

Depth: Depth of cut. The routing head can be used as a floating head or

a fixed head. The depth of cut is set up physically on the head with the

micrometer setting in case of floating head. Calling out a value here

merely adds pressure to the head in order to make sure that the floating

head is firmly riding on the material. However, remove the floating

head and the routing head will act like a routing bit. The bit in this case

will try to travel down along the Z axis for the depth of cut that is

called out in the software set up.

Lift: Lift or amount the cutter in inches will move up between cuts.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 110