Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 44)

44 MaxMotion for Machines

( 3) Adjust the setting for the surface and get ready for the job

(Virtual Controller & Motorized Z-axis only)

Step 1. Go to the starting position of the job in one of the following

ways:

A. Set the material anywhere on the table and move the tool

to the defined starting position (One of the six in Section III,

Machine Setup) of the material as your temporary home by

using the control pad.

B. If the machine has limit switches, MaxMotion is

configured with limit switches and proper offsets.

(1) If you start your jobs from upper left position, and you

position the material to the upper left position, simply Go

Home from the Control Pad and you are at the starting

position.

(2) If you have a machine with vice in the center of the table,

you start your jobs from center or top center position, and you

position the material in the vice, simply Go Home from the

Control Pad and you are at the starting position.

Step 2. Depress ‘S’ key for starting and release it.

Step 3. Move the tool to the surface area of the material with the help

of Control Pad.

Step 4. Move the Z-axis with Control Pad.

Step 5. When the lower tip of the tool touches the surface of the

material, depress the ‘Surface’ key on the Control Pad.

Step 6. The Z-axis will move up to the value of the lift declared in the

material menu.

Step 7. Either depress ‘ESC’ or ‘H’ key for home.

Step 8. The tool (Z-axis) will move back to the temporary or

permanent home.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 44