Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 112)

112 MaxMotion for Machines

engraving machines,

The following changes have been made:

Print command will print only a dot, not target symbol. Stationary

template will not be printed. Design plate will be printed only if 'Cut

design window' is enabled. Offset and fill will be printed. When you

print on a printer, now a dot will be difficult to see, having been

stripped of target symbol.

(2) Now you can specify printer starting position as well as orientation

in item PRINTER_STARTPOS_ROTATION in section GlobalValues

of .INI file. This is useful for laser engraving. Value 0 means bottom-

left, 1 means top-left, 2 means bottom-left rotated at 90, 3 means top-

left rotated at 90. Values 2 and 3 are not likely to be needed, as 'Setup'

in Print dialog allows you to choose between Portrait and Landscape

orientations. You may recollect, this dialog comes up only if you have

ShowPrintDialog=1 in your .INI file. If you wrongly configure

between top-left and bottom-left, you can print upside down mirror

image, except for fonts which will not flip.

Exit (Ctrl+Q)

Selecting Exit will close the program and remove it from the RAM

memory.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 112