Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 237)

MaxMotion for Machines Appendix E-237

in your computer. If you have a printer connected to the

parallel port, disconnect the printer cable, connect the ID key,

tighten the screws, and reconnect the printer cable to the other

side of the ID key.

D. Make sure and connect the MaxAmp unit per installation

instructions in procedure E1.

E. The unique interface cable from the MaxAmp unit to the

Newing Hall table will have a 25 pin connector at the end of

the cable. This will connect directly to the matching interface

connector in the back of the engraving machine.

F. Connect the 25 pin interface connector into the back of your

engraving table.

G. Turn the power on to the system in the proper manner. If you

try to turn the screw on the table to move either axis, you

should feel the resistance.

H. Since you are working with MaxAmp module, do not select

either old or new EC controllers in the selection of the

engraving machine for the output. You should select MaxAmp

Newing as the output device. This tells the software that you

are driving the Newing Hall engraving machine with our

driver module.

CAUTIONS

A. There are no limit switches exist on Newing Hall 100 to 400 series

of machines.

B. You should use our 10 key Controlpad implementation to jog the

tool to the starting point of a job. Next, you should NOT use the

SURFACE command to set the Z axis. Simply use Z down key to

actuate your selected solenoids. You may have selected either left or

right or both solenoids.

E5. Installation instructions for MaxAmp Driver box to Hermes

810

STEP ONE

A. Make sure you have at least two printer ports in your Windows

computer.

B. Make sure that your PC meets the minimum requirements

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 237