Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 16)

16 MaxMotion for Machines

Section II

General setup section II will allow you to setup limit switches and the

distance you desire from the limit switches, once you reach home.

If you have a machine (e.g. Newing Hall engraving machine with TLC

controller) with no limit switches, the Section II will be set up with

Limit Switches "Not Present" in all three axis. The limit switch part of

the logic will not be activated in the application.

However, if you do have a machine with limit switches (e.g. New

Hermes 3000), notice the setup of the limit switches by simply select-

ing the machine name to be New Hermes 3000. For a new machine, set

Pin 12 for the X axis

Pin 13 for the Y axis

Pin 10 for the Z axis

It is important to find out whether the limit switch position will provide

a logic 1 or a logic 0 when the limit switch is not tripped. The axis shall

be set to that high or low value in section II. It is important to note that

it is not a good idea to position the starting position right at the limit

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 16