Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 151)

MaxMotion for Machines Chapter 9-151

■ Save the Matrix Preference Settings.

Batch/Matrix Output (F12)

8. Go to the JOB DESIGN pull down menu and select Batch/Matrix

Output. Batch/Matrix Output dialog box will show up.

9. All the previously selected parameters show up. If it is a Batch

operation, click select the box material size same as the Plate and you

are ready to set one plate job at a time. The only other choice need to be

made is the starting point of the job.

10. Click SEND or depress RETURN key after replacing the engraved

plate with a new plate in the same place on the table. The current plate

count will be updated by the MaxMotion every time. Scoring operation

will not be necessary in the batch mode.

11. Do not click select the box material size same as plate size, if it is a

Matrix operation. Select the starting point of the job and MaxMotion

will engrave as many plates as it can fit on the given size of the

material. It will pause for the scoring operation. At the end of scoring

the material, MaxMotion will pause again and will be ready for further

operation on the new material, if there are still plates to be engraved to

complete the job. It will position the pointer of the job to the next

variable job. The operator will only require to click the SEND key

when ready.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 151