Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 130)

130 MaxMotion for Machines

EXTRA_CHAR_SPACE in section ‘Global Values’) and a new layout

starts with this settings. “Revert to Default’ reads from .INI and writes

in the box. Edit Layout Dialog also enables to set ‘Extra Space’ of a

line.

If entire line is highlighted while doing Ctrl + up (or down) arrow, the

extra space of the line is automatically updated accordingly and is

reflected in dialog boxes. Subsequent characters appended to this line

will respect this setting. When file saved with this version onwards is

opened again, it will remember general as well as individual lines

‘Extra Space’ settings.

Now a text line can be stretched visually just by dragging it, in addition

to changing it from font and edit layout dialogs. If left or right edge of

the selection box around a flat text is dragged, the text stretches along

with it. Font dialog and edit layout dialog reflect this with change in

width percent accordingly. If the line is fit aligned or restricted by

margin or due to other similar lines, it will not stretch.

The feature to create a line at an angle works in the following

manner:

When a line is selected, font dialog shows line angle. This can be

changed to turn the line at an angle. The same can also be done from

edit layout dialog. Font dialog only turns around reference (according

to alignment), without worrying about margin or baseline, but the edit

layout dialog moves the turned text to maintain the specified margin

and baseline. Edges of the selection box of angled text cannot be

dragged to either enlarge or contract the box containing the angled text.

However, the complete box can be moved anywhere on the plate or

outside the plate. Neither an angled text can be turned into arc, nor an

arc can be rotated at an angle.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 130