Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 218)

218 MaxMotion for Machines

(17) My machine is moving in wrong direction when I use Control

Pad to move the table around. How do I correct it?

First of all, turn off the power to the MaxAmp module. Move all the

axis away from the limit switches, if the machine has the limit

switches. Turn the power back on to the MaxAmp module.

Use the control Pad to move the individual axis and make a note if any

one or more of the axis are moving in the wrong direction.

Go to File pull down menu and select Machine Setup.

Make sure that the proper machine is selected.

Click on the Machine Setup section I.

Note that direction setup is available for each of the axis.

The radio buttons High and Low can be toggled.

Toggle the radio button only for the axis where the machine was

moving in the wrong direction.

Save the changes and click OK to close the Machine setup area.

Use Control Pad again to confirm the correct directions in each of the

axis.

Caution: You should not exercise the limit switches to go home until

you make sure that the directions of movement are proper for all the

axis.

(18) I installed the HPGL version of MaxMotion to control my

machine through my HPGL compatible controller. It does not work

yet. Any suggestions?

The most common problem if it does not work right after the first

install is possibly the setting or the installation of the Generic/TEXT

driver available with the Microsoft Windows.

Read the chapter on the installation again. If necessary, call us for help.

(19) What do I need to do to change from NoteTabPro to the

NotePad (provided by Microsoft with Windows operating system)

as the default editor?

■ Open the INI file under Microsoft WordPad.

■ Move your cursor down a few pages until you see the part that looks

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 218