Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 183)

MaxMotion for Machines Chapter 12-183

If it is necessary to adjust both the width and the height of the job, you

may adjust them independently by unchecking the Proportional check

box. You can then enter the dimensions you desire into each box

without affecting the other. You may also scale the entire job by a fixed

percent value. If you want the change in size to be relative to the

current overall dimensions of the job you should enter the new percent-

age into the box labeled “of current.” If you want to resize the drawing

to a percentage based on the overall dimensions of the plot file when

the file was first opened, then enter the new percentage into the box

labeled “of original.”

If any shapes are selected when the “Scale...” menu choice is made, an

additional scaling option becomes active - The”All By Selection”

mode. The dimensions of any shape or group of shapes currently

selected is also displayed. You may now change the dimensions

of the selection, using the same techniques described above for scaling

the entire drawing, and the dimensions of the drawing will change

proportionally.

You can also limit your scaling to a “Selection Only” by choosing this

scale option, and then follow the same procedures as above.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 183