Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 239)

MaxMotion for Machines Appendix E-239

same plate dimensions and positioning the new plates in the same

place, you need not bring the tool back by jogging. The software knows

the starting and ending positions and it will automatically come back to

starting position upon sending the next job.

C. Be sure to read the manual and ask us for our latest information as

well as our “How To...” notes to learn the use of MaxMotion quickly

and easily.

E6. Installation instructions for MaxAmp Driver box to Hermes

1219/Meistergram 1912

STEP ONE

A. Make sure you have at least two printer ports in your Windows

computer.

B. Make sure that your PC meets the minimum requirements

defined in the System Requirements chapter.

C. Connect the MaxMotion ID key to your existing parallel port

in your computer. If you have a printer connected to the

parallel port, disconnect the printer cable, connect the ID key,

tighten the screws, and reconnect the printer cable to the other

side of the ID key.

D. Make sure and connect the MaxAmp unit per installation

instructions in procedure E1.

STEP TWO

A. Notice a 25 pin female connector that is coming out of the

amplifier module for the machine cable You may need to

disconnect the existing interface connector from the 1219

controller.

B. Attach the spindle motor cable to the spindle motor outlet

provided on the amplifier box. The spindle motor will be

controlled to turn on and off automatically with the job. Do

not turn on the spindle motor if the job requires diamond drag

by either deselecting the spindle motor in the MaxMotion

configuration setup or with the control button on the table.

CAUTIONS

A. The limit switch wiring is connected and it is to be used for going

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 239