Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 174)

174 MaxMotion for Machines

Default Settings

Default settings allow you to set up many of the settings that you may

need to set up only once and may not need to change too often.

You can set up the unit of dimensions as inches, centimeters, or

millimeters.

You can set up the unit of time as seconds or minutes.

You can set up the unit of tool size as inches, or millimeters.

You can set up the default tool size for offset, fill (or pocketing), and

for the “other” tool size.

Many times operators like to call out the same tool size for the sake of

speed and simplicity of routing operation. However, you can request a

larger diameter tool for fill paths to clean out the shape from inside

while a regular diameter tool for finishing outline edges. You end up

changing the tool but you may gain speed and accuracy. The default

settings are simply recommendations. Actual cutter size should be

determined by the size of your design elements.

It was always possible in MaxMotion to select a shape or shift + select

a bunch of shapes and drag them with the pointer tool to anywhere you

want on the plate or outside the plate. (It is important to note that any

shape outside the plate will not be processed when the job is sent to the

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 174