Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 240)

240 MaxMotion for Machines

home. You can simply utilize the Home key in the control pad and the

spindle will move to the Home position.

B. You should use our 10 key Controlpad implementation to jog the

tool to the starting point of a job. Next, you should use the SURFACE

command to set the Z axis. If you are repeating similar jobs with the

same plate dimensions and positioning the new plates in the same

place, you need not bring the tool back by jogging. The software knows

the starting and ending positions and it will automatically come back to

starting position upon sending

C. Be sure to read the manual and ask us for our latest information as

well as our “How To...” notes to learn the use of MaxMotion quickly

and easily.

E7. Installation instructions for MaxAmp Driver box/Hermes 3000

STEP ONE

A. Make sure you have at least two printer ports in your Windows

computer.

B. Make sure that your PC meets the minimum requirements

defined in the System Requirements chapter.

C. Connect the MaxMotion ID key to your existing parallel port

in your computer. If you have a printer connected to the

parallel port, disconnect the printer cable, connect the ID key,

tighten the screws, and reconnect the printer cable to the other

side of the ID key.

D. Make sure and connect the MaxAmp unit per installation

instructions in procedure E1.

STEP TWO

A. Notice three white Molex connectors with X, Y, and Z written

on them that are coming out of the amplifier module. These

will go into the NH3000 machine.

B. Orient yourself such that you are facing the back of the

NH3000 machine.

C. Disconnect power supply.

D. Also, disconnect interface to the existing front end by

disconnecting the 34 pin black connector.

E. Note that there are two plate covers one on the left and the

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 240