Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 223)

MaxMotion for Machines Appendix C-223

Appendix C

Configuration of Parallel Port

Standard configuration of Parallel Port of PC

for MaxMotion Multi-Axis Indexer

Parallel port on the back of a PC has a 25 pin female connector. Most

computers may have only one parallel port. However, a PC can be

configured with as many as 3 parallel ports. You can use any one of

them to connect to the XYZ table. Following is the pin configuration:

DB-25 pin outs Signals

1 ———————————— Right output switch

2 ———————————— X - Step

3 ———————————— X - Direction

4 ———————————— Y - Step

5 ———————————— Y - Direction

6 ———————————— Z - Step

7 ———————————— Z - Direction

8 ———————————— +5 V. DC for opto-isolators

9 ———————————— +5 V. DC-Possible for limit

switches

10 ——————————— Limit switch - Z axis

11 ——————————— Future Use

12 ——————————— Limit switch - X axis

13 ——————————— Limit switch - Y axis

14 ——————————— Left output switch

15 ——————————— future use

16 ——————————— Spindle motor enable

17 ——————————— Amplifiers/Drivers enable

18 - 25 ——————— —— Ground lines

This will be a standard configuration. Custom configurations are

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 223