Roland CAMM-2 PNC-2300 Owner's Manual download pdf (Page 246)

246 MaxMotion for Machines

well as our “How To...” notes to learn the use of MaxMotion quickly

and easily.

E10. Installation instructions for MaxMotion to Dahlgren Wizzard

PC machines using A/B Switch box.

STEP ONE

A. Make sure you have at least one printer ports in your PC/

Windows computer.

B. Make sure that your PC meets the minimum requirements

defined in the System Requirements chapter.

C. Connect the MaxMotion ID key to one of the existing parallel

ports in your computer. If you have a printer connected to the

parallel port, disconnect the printer cable at the computer end,

connect the ID key to the parallel port first, tighten the screws

on the ID key, and reconnect the printer cable to the open side

of the ID key.

D. Install the High current card in the card slot in the back of

your computer.

E. Guide the flat cable from the B position of the A/B box to the

high current card in the back of your Computer.

STEP TWO

A. Turn the Wizzard PC machine upside down and remove eight

screws along the edge of the machine. Turn the machine back

and remove the top cover.

B. Note four screws inside the metal holding pan for the table.

These screws are responsible for holding the table in place.

Remove the screws.

C. Disconnect the 15 pin connector from the rear of the PC board

on top of the monitor. Then carefully lift the table and rest it

on its side in the back of the machine. You will connect this

back when you are done with the full installation.

D. Note a black metal plate when you remove the table. The

metal plate has a number of holes through which you can see a

PC board underneath. Also, note a number of cables connected

to the PC board through the holes.

E. Additionally, note four rubberized screw holders. The

engraving table actually rests on these holders. Unscrew all

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 252

No comments

Roland CAMM-2 PNC-2300 Owner's Manual Page 246